GarrettCom 6K32T Manual De Usuario

Magnum 6K32T & 6K32TRC Managed Switch          Installation and User Guide 05/07) 

 
 

40

 

 

.

.

the PM Face plate card slot securely. These six screws shown in the picture below are 

used to secure a PM face plate in position, but unscrew only four of the screws as shown 

in Fig. below. These screws are also used to secure the individual 6KPM cards screen 

plate which can be subjected to significant forces from the attached cables.  (See Figure 

3.5.1d) 

 

Up to four front-mounted 6KPM cards may be installed in one Magnum 

6K32T & 6K32TRC Managed Switch unit. Follow these steps to install a 

6KPM. 

Step 1.  Remove top chassis cover. See procedure in Section 3.5.1 above.  

Step 2.  Placed Granddaughter board (as shown in fig. 3.5.2a and 3.5.2b) on the chassis 

built in stand off (female) provided at the front of the 6K32T & 6K32TRC Main Board 

and screw down tightly with the three 5/16 stand-off (male) on the top of the 

Granddaughter board The 5/16 stand off has been used to place the daughter board on the 

top of the granddaughter board and latch it securely.