GarrettCom P80C Manual De Usuario

Magnum P80F & P80C Personal Switches                      Installation and User Guide (07/03)

 

 

 

 

18 

.

.

(FLP) coding for the 100BASE-TX signaling system.  When connecting a NIC to the P80F or 

P80C, it may be necessary to reload the NIC drivers on the user device if the NIC has been 

communicating with a protocol other than 100BASE-TX (such as 10BASE-T).  When 100Mb 

operation is agreed and in use, the  SPEED  LED is illuminated steady ON.  It is OFF if there is 

no traffic or if 10 Mbps traffic. 

Each Magnum P80F and P80C Personal Switch is provided with an external power 

supply, and has a jack for the DC power cord in the rear. A lightweight DC power cord for  

5V, 2.0 amps is supplied with each unit. The small DC power cord from the power supply plugs 

into the matching rear power jack of the P80F and P80C Personal switchess.  When the power is 

applied, the green PWR LED will illuminate. 

 

Each Magnum P80F and P80C power supply supports standard AC installation 

environments and comes in two types; one version for AC input power of 115vac at 60Hz for “-

d ” models, and other version of 230vac at 50 Hz for “-i ” models that have IEC power cable 

connector in the external power unit.  

 

Examine the power supply to make sure the version you have is the right type for your 

AC power system. The 115vac version has a small transformer integral with a convenience 

power outlet plug, and a lightweight DC power cord to the applicable power jack on the Switch. 

The 230vac version has a small transformer integral with an IEC-type power plug for a user-

supplied AC power cord with a convenience power outlet plug.