Avaya M770 Manual De Usuario
Chapter 16
Managing an ELAN
Avaya M770 ATM Switch User’s Guide
215
To change the operating mode of LESes for a specific ELAN, use the
lane elan
les
command:
Note:
You can set a specific automatic registering mode for an ELAN. For more
information see Changing the Automatic Registration Mode of an ELAN later in
this chapter.
this chapter.
Changing the Automatic Registration Mode of an ELAN
You can set the automatic registration mode for an ELAN. The automatic registering
modes are:
•
modes are:
•
resilient - the ELAN will adopt the resilient automatic registering mode.
•
distributed - the ELAN will adopt the mode that supports distributed LANE
Services.
Services.
•
autosense - the ELAN will adopt the mode from the first registering LES.
For more information about the above automatic LES address determination
methods, see Chapter 13, “LANE Services”.
To change the automatic registration mode of an ELAN, use the
methods, see Chapter 13, “LANE Services”.
To change the automatic registration mode of an ELAN, use the
lane elan
autovers
command:
Note:
The above change does not affect the ELAN until the next time it is activated.
Note:
You must change the ELAN automatic registration mode to distributed before
using any of the commands in this Chapter which alter the way distributed ELANs
are used.
are used.
Command:
M15-155s8:/>lane elan les <name> [auto | <atm-addr>]
Example:
M15-155s8:/>lane elan les elan1 auto
Parameters:
<name>
The name of the ELAN.
auto
Select only if an M770 LES will host the ELAN.
<atm-addr>
Enter the full ATM address of the LES that will host the
ELAN.
ELAN.
Command:
M15-155s8:/>lane elan autovers <name> <automode>
Example:
M15-155s8:/>lane elan autovers accounts_elan distributed
ELAN autoregistration mode set to distributed
Parameters:
<name>
The name of the ELAN, this must be 32 characters or less.
<automode>
Select one of the following automatic registration modes: resilient,
distributed, or autosense.
If this last parameter is not entered then the automatic registering
mode for the specified ELAN will be displayed.
distributed, or autosense.
If this last parameter is not entered then the automatic registering
mode for the specified ELAN will be displayed.