Alcatel-Lucent 6600 Series Manual De Usuario

Mounting the Switch

OmniSwitch 6600 Series Chassis and Hardware Components

page 2-16

OmniSwitch 6600 Series Hardware Users Guide

7 Once the screws at the bottom of each flange are secure, install the remaining two rack mount screws. 
Be sure that all screws are securely tightened.

Note. If you are installing multiple switches in a rack to form a stacked configuration, refer to the 

 section below.

If you are rack mounting multiple switches in a stacked configuration, be sure to place all switches in 
vertically-adjacent rack positions. This will ensure that all required stacking cables will have adequate 
length for the installation. For additional instructions on rack mounting a stacked configuration, follow the 
steps below:

1 Install the rack mount flanges for all switches that are to be included in the stacked configuration, as 
described on 

. Up to eight switches may be stacked to form a single virtual chassis.

2 Place the next switch in the stack directly on top of the previously installed switch.

3 Align the holes in the flanges with the holes in the rack’s vertical posts. 

4 Once the holes are aligned, insert a rack mount screw through the bottom hole of each flange. Tighten 
both screws until they are secure.

5 Repeat steps 1 through 4 above for all remaining switches.