Alcatel-Lucent 6600 Series Manual De Usuario

Back Up Power Supply

OmniSwitch 6600 Series Chassis and Hardware Components

page 2-18

OmniSwitch 6600 Series Hardware Users Guide

OmniSwitch 6600 series switches provide one factory-installed power supply per chassis. Each switch also 
provides one bay for the optional OS66BPS-100A back up power supply. The back up power supply bay 
is located on the chassis rear panel (see 

 for details). 

For information on installing a back up power supply, refer to 

. For information on removing a 

back up power supply, refer to 

After a back up power supply is installed, the primary (factory-installed) power supply continues to take 
on the full power load for switch operations. Meanwhile, the back up power supply operates in active 
standby mode. If the primary power supply fails unexpectedly, the back up power supply automatically 
takes up the full power load without disrupting the switch.

Input Voltage

85 to 250 VAC

Input Frequency

47 to 63 Hz

Efficiency

75% measured at 115 VAC

Temperature

Operating: 0 to +50 Celsius
Non-Operating: - 40 to +85 Celsius

Relative Humidity

5% to 95% non -condensing

Altitude

10,000 feet @ +32 Celsius

THIS UNIT MAY BE EQUIPPED

WITH TWO POWER CONNECTIONS. TO REDUCE
THE RISK OF ELECTRICAL SHOCK, DISCONNECT
BOTH POWER CONNECTIONS BEFORE
SERVICING UNIT.

CET APPAREIL COMPORTE

PLUS D'UN CORDON D'ALIMENTATION. AFIN DE
PREVENIR LES CHOCS ELECTRIQUES, DEBRANCHE
LES DEUX CORDONS D'ALIMENTATION AVANTE DE
FAIRE LA REPARATION.

indicates on position; 
indicates off position.

Power Connector Socket.
Type IEC-320-C13. Supports
one 10 amp power cord. 

It is recommended that you use
Alcatel-provided power cords.

Product, Safety, and Compliance Information.
Refer to the “Regulatory Compliance and Safety
Information” chapter for detailed information.