Cisco Systems UCSEZINFRACHSS Manual De Usuario
Installing and Removing a Power Distribution Unit (PDU)
The Power Distribution Unit should only be replaced by a Cisco certified technician. This section is for
reference only.
reference only.
Caution
You can not hot swap a PDU (N01-UAC1). The entire chassis will need to be shut down and all power
cords should be unplugged before attempting this procedure.
cords should be unplugged before attempting this procedure.
Caution
Installing a PDU
Procedure
Step 1
Hold the PDU module from below, with the captive screws at the top of the module.
Figure 38: Positioning a PDU (N01-UAC1) in the Cisco UCS Server Chassis, AC Version
195360
1
Step 2
Push the PDU module into the chassis until it seats properly. If power supplies are installed, you may need
to partially remove them.
to partially remove them.
Step 3
Tighten the captive screws.
Step 4
If necessary, reseat the power supplies and restart the system to observe LED behavior.
Cisco UCS 5108 Server Chassis Installation Guide
62
OL-20035-05
Installing and Removing Components
Installing and Removing a Power Distribution Unit (PDU)