Cisco Systems SFS 7008 Manual De Usuario

Descargar
Página de 108
44
Installing a Fabric Controller
1. Remove the new Fabric Controller module from the packaging. 
2. Ground yourself appropriately. 
3. Remove the bezel cover, if you have not already done so.
4. Refer to 
, if a Fabric Controller module is still installed. 
5. Remove the blanking panel, if no fabric controller was previously installed. 
6. Align the new Fabric Controller module with the bay into which you want to install it. 
7. Gently push the Fabric Controller module into the bay as far as you can. 
8. When the module is nearly completely installed, press the levers in toward the Fabric Controller 
until they are flat against the module. 
9. Check the LEDs on the Fabric Controller module and the chassis to verify the status. Refer to 
.
10. Tighten the captive screws on both ends of the Fabric Controller module. 
Figure 3-11: Tight the Captive Screws
11. Refer to 
Upgrading the Controller Card
It is likely that the image version on the new Fabric Controller card will not match the firmware on the 
rest of the chassis. After the new Fabric Controller module has been installed, upgrade the firmware on 
the chassis and the new Fabric Controller will be upgraded automatically. 
The version of the firmware is verified during the upgrade process. If a module does not need to be 
upgraded, the module will be skipped and move on to the next module. 
The image can be upgraded with the following methods