Cisco Systems SFS 7008 Manual De Usuario

48

7. Install a blanking panel in place of the LIM module, or refer to 

 for instructions on replacing the LIM module. 

1. Remove the new LIM module from the package. 
2. Refer to 

, if a LIM module is still in place. 

3. Ground yourself appropriately. 
4. Remove the blanking panel if a LIM module was not currently in place. 
5. Align the LIM module and slide it into the bay as far as possible. The module will not go into the 

bay completely without closing the levers. 

6. When the LIM module is nearly installed in the bay, press the levers in toward each other. 

Figure 3-17: Closing the LIM Module Levers

7. Check the LIM status LED to determine that the module is functioning properly. Refer to 

.

8. Tighten the captive screws on both ends of the LIM card. 

Figure 3-18: Tighten the Captive Screws