Cisco Systems SFS 7008 Manual De Usuario

49

9. Connect the InfiniBand cables to the ports. 

a.

To plug in an InfiniBand cable, push the connector into the interface until you hear/feel a 
click.Check the InfiniBand port LEDs to determine the status of the port. Refer to 

. 

Refer to 

 for additional information. 

If you believe a Management Interface module has failed, contact technical support. Management 
Interface modules are hot-swappable. 
Refer to 

 for 

monitoring information. 

The Management Interface modules are located on the back of the chassis. Refer to 

 for a 

diagram of the chassis. The slots are labelled on the chassis. 

1. Verify that you have a method of covering the slot before removing the module. Do not remove the 

module unless you have a replacement or a blanking panel for the slot, as overheating may occur. 

2. Determine if the Management Interface module that you are removing is currently connected to the 

master fabric controller. 
Note: The removal of the “Master” Management Interface module will trigger a fail-over of the 
Fabric Controller module. Switch traffic will be disrupted. If the system is left without a 
Management Interface card, the switch will become inoperative.
If the “Master” LED is lit, then the module is connected to the master fabric controller module, and 
a fail-over will occur when you remove the management interface module. The system will fail to 
the redundant management interface module and the redundant fabric controller module. 

3. Ground yourself appropriately. 
4. Unplug any Ethernet management or serial cables that are connected to the ports of the 

Management Interface module. 

5. Use a #1 phillips screwdriver to unscrew the Management Interface module.
6. Use the handle to pull the module from the bay. 

Figure 3-19: Example of the Management Interface Module