Canon Model 6401 B Manual De Usuario
Field Test Unit Software
To use the 8k 6264LP RAM supplied to increase the FTU memory to 16k
switch the FTU off and remove the cover of the chip socket on the back of
the FTU.
the FTU.
Replace the FTU ROM with the RAM chip and change the memory select
switch from ROM to RAM. Replace the cover press the reset button on the
back of the FTU and switch on.
switch from ROM to RAM. Replace the cover press the reset button on the
back of the FTU and switch on.
R A M Programs in RAM
Command Files Log Programs
Data
16K
PLOT
RAM/Cassette RAM/Cassette Cassette
(in text area)
16K
LOAD/COPY/FTUC RAM/Cassette RAM/Cassette Cassette
(in RAM file)
24K PLOT/COPY/FTUC RAM/Cassette RAM/Cassette Cassette
2.3 FTU INITIALIZATION
If for any reason the FTU programs need to be loaded, the following proce-
dure should be used:-
dure should be used:-
1.
2.
3.
4.
5.
6.
7.
Using a pencil, press the RESET button at the rear of the
FTU. (This is a Master Reset, so ALL PROGRAMS WILL
BE LOST).
FTU. (This is a Master Reset, so ALL PROGRAMS WILL
BE LOST).
Connect FTU to Cassette Recorder with Model 6302A
software cassette tape inserted/rewound and ready to use.
software cassette tape inserted/rewound and ready to use.
Press ON/BREAK key on the FTU. The message “14940
Bytes free” will appear. (Note: at least 14940 Bytes are re-
quired to operate this software, more ‘free’ bytes are fme).
Bytes free” will appear. (Note: at least 14940 Bytes are re-
quired to operate this software, more ‘free’ bytes are fme).
Type:- FSET 10000 Return (2300 if using PLOT/PLOTX)
Type:- CLOAD “FTUC” Return (system should respond with
‘Found FTUC’ and then continue to read the program
FTUC from the cassette tape and store it in the FTU)
Type:- SAVE “FTUC” Return (to save the program FTUC
permanently in the FTU’s RAM file area.) SAVE
“LOAD/UNLOAD”
“LOAD/UNLOAD”
Repeat Steps 5 & 6 above to Load & Save programs
“LOAD” and “COPY”. Program “PLOT” may also be loaded
if there is sufficient RAM in the FTU [in this case, “PLOT”
should be LOAD(ed) and SAVE(ed) first, then “FTUC”,
“LOAD” and “COPY”).
“LOAD” and “COPY”. Program “PLOT” may also be loaded
if there is sufficient RAM in the FTU [in this case, “PLOT”
should be LOAD(ed) and SAVE(ed) first, then “FTUC”,
“LOAD” and “COPY”).
6
Section 2. GETTING STARTED