Schneider Electric TSXCUSBMBP Manual De Usuario
Installation
35011984 02/2006
17
Installing the TSXCUSBMBP Driver Software
Introduction
The TSXCUSBMBP Driver must be installed before connecting the TSXCUSBMBP
device to the USB port.
device to the USB port.
How to install the
TSXCUSBMBP
Driver?
TSXCUSBMBP
Driver?
Use the following procedure to install the Driver software.
Installing the TSXCUSBMBP Hardware
Introduction
The TSX C USB MBP can be connected directly to a USB port on the PC or
through a USB Hub. The TSXCUSBMBP acquires power from the USB port or Hub,
therefore no power connection is required.
through a USB Hub. The TSXCUSBMBP acquires power from the USB port or Hub,
therefore no power connection is required.
Step Action
1
Insert the CD-ROM labeled TSXCUSBMBP Driver into your CD-ROM drive.
2
The installation should begin automatically. If not, follow the procedure below to start
the installation manually.
the installation manually.
z
From the Start menu (Start button on Windows XP task bar), select Run
z
Type in D:\Setup.exe (if your CD-ROM drive is not D:, substitute the drive letter of
your CD-ROM drive) and press Ok.
your CD-ROM drive) and press Ok.
3
Follow the on-screen instructions to complete the software installation.
4
The final step of the software installation will display a message window containing
instructions. Please read the instructions carefully.
instructions. Please read the instructions carefully.
Note: Do not connect the Modbus Plus network cable to the Modbus Plus port on
the TSXCUSBMBP until after the Modbus Plus Node Address has been configured
in the Driver Software. This will avoid the potential for duplicate Modbus Plus node
addresses on your network.
the TSXCUSBMBP until after the Modbus Plus Node Address has been configured
in the Driver Software. This will avoid the potential for duplicate Modbus Plus node
addresses on your network.