Cisco Systems ASA 5580 Manual De Usuario

31-6

Cisco ASA Series Firewall CLI Configuration Guide

Chapter 31 Configuring the ASA IPS Module

Default Settings

http://www.cisco.com/en/US/docs/security/asa/compatibility/asamatrx.html

•

The ASA 5505 does not support multiple context mode, so multiple context features, such as virtual
sensors, are not supported on the AIP SSC.

•

The ASA IPS module for the ASA 5510 and higher supports higher performance requirements,
while the ASA IPS module for the ASA 5505 is designed for a small office installation. The
following features are not supported for the ASA 5505:

–

Virtual sensors

–

Anomaly detection

–

Unretirement of default retired signatures

Additional Guidelines

•

The total throughput for the ASA plus the IPS module is lower than ASA throughput alone.

–

ASA 5512-X through ASA 5555-X—See
http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6032/ps6094/ps6120/qa_c67-700608.
html

–

ASA 5585-X—See
http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6032/ps6094/ps6120/qa_c67-617018.
html

–

ASA 5505 through ASA 5540—See
http://www.cisco.com/en/US/prod/collateral/vpndevc/ps6032/ps6094/ps6120/product_data_sh
eet0900aecd802930c5.html

•

You cannot change the software type installed on the module; if you purchase an ASA IPS module,
you cannot later install other software on it.

Default Settings

Table 31-1

lists the default settings for the ASA IPS module.

Note

The default management IP address on the ASA is 192.168.1.1/24.

Table 31-1

Default Network Parameters

Parameters

Default

Management VLAN (ASA 5505 only)

VLAN 1

Management IP address

192.168.1.2/24

Gateway

192.168.1.1/24 (the default ASA management IP address)

Username

cisco

Password

cisco