Cisco Systems ASA 5580 Manual De Usuario
3-8
Cisco ASA Series Firewall CLI Configuration Guide
Chapter 3 Information About NAT
NAT Types
Note
For the duration of the translation, a remote host can initiate a connection to the translated host if an
access rule allows it. Because the address is unpredictable, a connection to the host is unlikely.
Nevertheless, in this case you can rely on the security of the access rule.
access rule allows it. Because the address is unpredictable, a connection to the host is unlikely.
Nevertheless, in this case you can rely on the security of the access rule.
Dynamic NAT Disadvantages and Advantages
Dynamic NAT has these disadvantages:
•
If the mapped pool has fewer addresses than the real group, you could run out of addresses if the
amount of traffic is more than expected.
amount of traffic is more than expected.
Use PAT or a PAT fallback method if this event occurs often because PAT provides over 64,000
translations using ports of a single address.
translations using ports of a single address.
•
You have to use a large number of routable addresses in the mapped pool, and routable addresses
may not be available in large quantities.
may not be available in large quantities.
The advantage of dynamic NAT is that some protocols cannot use PAT. PAT does not work with the
following:
following:
•
IP protocols that do not have a port to overload, such as GRE version 0.
•
Some multimedia applications that have a data stream on one port, the control path on another port,
and are not open standard.
and are not open standard.
See the
for more information about NAT
and PAT support.
Dynamic PAT
This section describes dynamic PAT and includes the following topics:
•
•
•
Information About Dynamic PAT
Dynamic PAT translates multiple real addresses to a single mapped IP address by translating the real
address and source port to the mapped address and a unique port. If available, the real source port number
is used for the mapped port. However, if the real port is not available, by default the mapped ports are
chosen from the same range of ports as the real port number: 0 to 511, 512 to 1023, and 1024 to 65535.
Therefore, ports below 1024 have only a small PAT pool that can be used. If you have a lot of traffic that
uses the lower port ranges, you can specify a flat range of ports to be used instead of the three
unequal-sized tiers.
address and source port to the mapped address and a unique port. If available, the real source port number
is used for the mapped port. However, if the real port is not available, by default the mapped ports are
chosen from the same range of ports as the real port number: 0 to 511, 512 to 1023, and 1024 to 65535.
Therefore, ports below 1024 have only a small PAT pool that can be used. If you have a lot of traffic that
uses the lower port ranges, you can specify a flat range of ports to be used instead of the three
unequal-sized tiers.
Each connection requires a separate translation session because the source port differs for each
connection. For example, 10.1.1.1:1025 requires a separate translation from 10.1.1.1:1026.
connection. For example, 10.1.1.1:1025 requires a separate translation from 10.1.1.1:1026.