Cisco Systems ASA 5585-X Manual De Usuario

Create the media termination instance on the ASA for the Cisco Intercompany Media Engine Proxy. See 

. 

The media termination address you configure must meet these requirements:

If you decide to configure a media-termination address on interfaces (rather than using a global 
interface), you must configure a media-termination address on at least two interfaces (the inside and 
an outside interface) before applying the service policy for the Cisco Intercompany Media Engine 
Proxy. Otherwise, you will receive an error message when enabling the proxy with SIP inspection.

Cisco recommends that you configure the media-termination address for the Cisco Intercompany 
Media Engine Proxy on interfaces rather than configuring a global media-termination address.

The Cisco Intercompany Media Engine Proxy can use only one type of media termination instance 
at a time; for example, you can configure a global media-termination address for all interfaces or 
configure a media-termination address for different interfaces. However, you cannot use a global 
media-termination address and media-termination addresses configured for each interface at the 
same time. 

If you change any Cisco Intercompany Media Engine Proxy settings after you create the 
media-termination address for the proxy, you must reconfigure the media-termination address by 
using the no media-termination

command, and then reconfiguring it as described in this 

procedure. 

Create the media termination instance to use with the Cisco Intercompany Media Engine Proxy.

The example command lines in this task are based on a basic (in-line) deployment. See 

 for an illustration explaining the example command lines in this task.

To create the media termination instance for the Cisco Intercompany Media Engine Proxy, perform the 
following steps: