Cisco Systems 815 Manual De Usuario
Chapter 3 Troubleshooting
Recovering a Lost Password
3-4
Cisco 815 Integrated Services Router Hardware Installation Guide
OL-9558-01
Resetting the Router
Follow these steps to reset the router:
Step 1
Do one of the following:
•
If break is enabled, go to
•
If break is disabled, turn off the router, wait 5 seconds, and turn it on again.
Within 60 seconds, press the Break key. The terminal displays the ROM
monitor prompt. Go to
Within 60 seconds, press the Break key. The terminal displays the ROM
monitor prompt. Go to
Note
Some terminal keyboards have a key labeled Break. If your keyboard does
not have a Break key, refer to the documentation that came with the
terminal for instructions on how to send a break. To send a break in
Windows HyperTerminal, press Ctrl-Break.
not have a Break key, refer to the documentation that came with the
terminal for instructions on how to send a break. To send a break in
Windows HyperTerminal, press Ctrl-Break.
Step 2
Send a break. The terminal displays the following prompt:
rommon 2>
Step 3
Enter confreg 0x142 to reset the configuration register:
rommon 2> confreg 0x142
Step 4
Initialize the router by entering the reset command:
rommon 2> reset
The router resets, and the configuration register is set to 0x142. The router boots
the system image in flash memory and displays the following:
the system image in flash memory and displays the following:
--- System Configuration Dialog ---
Step 5
Enter no in response to the prompts until the following message is displayed:
Press RETURN to get started!
Step 6
Press Return. The following prompt appears:
Router>