Graco 258864 Manual De Usuario

Aim the inlet of the suction tube at the front of the material 
cup (towards Spray Tip/Guard Assembly) during installa-
tion.

The Fine-Finish Optimizer should be installed and used 
when spraying thin material such as stain or clear coats. 
The Fine-Finish Optimizer restricts the material flow 
resulting in a finer quality finish.

1.

Remove material cup and suction tube.

2.

Remove the cleaning tool before installing the 
Fine-finish Optimizer into the sprayer.

3.

Push Fine-Finish Optimizer into pump inlet until 
completely engaged and re-install suction tube.

Be sure to remove and clean the Fine-Finish Optimizer 
immediately after use. Store the Fine-Finish Optimizer 
on the Storage/cleaning Tool supplied to keep the hole 
clear of dried material.

Use only water-based or oil-based (mineral 
spirit-type) materials with flash point greater than 
100° F (38° C). Do not use materials which state 
“FLAMMABLE” on the packaging. For more informa-
tion about your material, request MSDS from distribu-
tor or retailer. 

Spraying certain materials may cause static 
build-up in the sprayer that can result in static 
shock to the user. If this occurs, first ensure the mate-
rial has a flash point greater than 100° F (38° C) and 
does not state that it is FLAMMABLE anywhere on the 
package. If still feeling a static shock, the material likely 
contains a non-mineral spirits fluid such as, but not lim-
ited to, xylene, toluene, or naphtha, which can build up 
static. Switch to an alternative material.

Use oil-based material outdoors or in a well-ventilated 
indoor area with a flow of fresh air.

Keep spray area well-ventilated. Keep a good supply 
of fresh air moving through the area.

Your sprayer is NOT compatible with harsh cleaners 
such as chlorine bleach. Using these cleaners will 
cause damage to the sprayer. 

Failure to install the Fine-Finish Optimizer when spraying 
thin materials will cause the spray pattern to pulsate.

ti15440a

ti15473a