Graco 258864 Manual De Usuario

This sprayer arrives from the factory with a small 
amount of test material in the system. It is important 
that you flush this material from the sprayer before 
using it for the first time:

1.

Fill material cup with water and thread onto sprayer.

2.

Put prime/relief valve to UP position, then hold trig-
ger in for 10 seconds.

3.

Put prime/relief valve DOWN to spray position.

4.

Reverse spray tip to UNCLOG position and trigger 
sprayer into a waste area.

5.

Engage trigger lock and put prime/relief valve UP to 
release pressure. 

6.

Unscrew and remove material cup.

7.

Disengage trigger lock, put prime/relief valve 
DOWN, hold sprayer slightly above material cup, 
and pull trigger to discharge fluid from pump.

8.

Discard material in cup.

NOTE: If the sprayer is angled or tilted too far, the 
suction tube will lose contact with the material and 
the sprayer will stop spraying. 

ti14992a

ti14999a

ti15425a

ti14991a

ti15491a

ti14999a

ti14994a

ti15478a

ti15511a