Wagner SprayTech 7000 Manual De Usuario

Wear suitable ear protection when working.

The safety-specific requirements for Airless spraying are speci-

fied in:

a)  The European Standard „Spray equipment for coating ma-

terials – safety regulations „ (EN 1953: 1998).

b)  The regulations of the German employer‘s liability insur-

ance association („Berufsgenossenschaft“) „Using liquid 

jets“ (BGV D15) and „Processing coating materials „ (BGV 

D25).

c)  Guidelines for construction and implementation require-

ments for liquid jets (spraying units) of the German indus-

trial employer‘s liability insurance association (ZH1/406).

The following safety regulations are to be observed in order 

to ensure safe handling of the Airless high-pressure spraying 

unit.

.

Only spray coating materials with a flash point 

of 21 °C or higher.

The flash point is the lowest temperature at 

which vapors develop from the coating ma-

terial. These vapors are sufficient to form an 

inflammable mixture over the air above the 

coating material.

Do not use the unit in work places which are 

covered by the explosion protection regula-

tions.

The unit is not designed to be explosion pro-

tected.

There must be no sources of ignition such as, 

for example, open fires, lit cigarettes, cigars or 

tobacco pipes, sparks, glowing wires, hot sur-

faces, etc. in the vicinity.

Attention, danger of injury by injection!

Never point the spray gun at yourself, other 

persons or animals.

Never use the spray gun without spray jet 

safety guard.

The spray jet must not come into contact 

with any part of the body.

In working with Airless spray guns, the high 

spray pressures arising can cause very dan-

gerous injuries. If contact is made with the 

spray jet, coating material can be injected 

into the skin. Do not treat a spray injury as a 

harmless cut. In case of injury to the skin by 

coating material or solvents, consult a doctor 

for quick and correct treatment. Inform the 

doctor about the coating material or solvent 

used.

Always secure the spray gun when mounting or dismounting 

the tip and in case of interruption to work.

When using a high operating pressure, pull-

ing the trigger guard can effect a recoil force 

up to 15 N.

If you are not prepared for this, your hand can 

be thrust backwards or your balance lost. This 

can lead to injury.

Wear breathing equipment during spraying work.

 

A breathing mask is to be made available to the user (regu-

lations of the German employer‘s liability insurance associa-

tion („Berufsgenossenschaft“) „Rules for the use of breathing 

masks“ (BGR 190), „Using liquid jets“ (BGV D15) and „Process-

ing coating materials „ (BGV D25).

s afet y regul at Ions