Wagner SprayTech 7000 Manual De Usuario

s afet y regul at Ions

Protective clothing, gloves and possibly skin protection cream 

are necessary for the protection of the skin.

Observe the regulations of the manufacturer concerning coat-

ing materials, solvents and cleaning agents in preparation, 

processing and cleaning units.

The permissible operating pressure for the spray gun, spray 

gun accessories, unit accessories and high-pressure hose 

must not fall short of the maximum operating pressure of 25 

MPa (250 bar or 3625 psi).

An electrostatic charging of spray guns and the high-pressure 

hose is discharged through the high-pressure hose. For this 

reason the electric resistance between the connections of the 

high-pressure hose must be equal to or lower than 1 MΩ.

Only use WAGNER original-high-pressure 

hoses in order to ensure functionality, safety 

and durability.

Electrostatic charging of the unit may occur 

during spraying due to the flow speed of 

the coating material. These can cause sparks 

and flames upon discharge. The unit must 

therefore always be earthed via the electrical 

system. The unit must be connected to an 

appropriately-grounded safety outlet.

The unit may only be connected to the mains network via a 

special feeding point with a residual-current device with INF 

≤ 30 mA.

Adequate ventilation to ensure removal of the solvent vapors 

has to be ensured.

The are to be provided by the unit user in accordance with the 

corresponding local regulations.

The object to be coated must be earthed.

(Building walls are usually earthed naturally)

When cleaning the unit with solvents, the 

solvent should never be sprayed or pumped 

back into a container with a small opening 

(bunghole). An explosive gas/air mixture can 

arise. The container must be earthed.

Danger of short-circuits caused by water in-

gression!

Never spray down the unit with high-pres-

sure or high-pressure steam cleaners.

These may only be carried out by a skilled electrician. No li-

ability is assumed for incorrect installation.

Unplug the power plug from the outlet before carrying out 

any repair work.

 

Changes to the device will affect all con-

nected guns.

Sudden pressure increases (activation/modi-

fication) can cause accidents.

Make sure that you know the status of all 

connected spray guns/accessories and in-

form all other users if necessary.

Do not suspend the device using the extendable shaft.