Jonsered HTE2123 Manual De Usuario

 

8

 

 – 

 

English

 

In countr

 

ies that have a warm and dry climate there is a 

significant risk of fire. We therefore fit certain mufflers with a 
spark arrestor mesh. Check whether the muffler on your 
machine is fitted with this kind of mesh.

For mufflers it is very important that you follow the instructions 
on checking, maintaining and servicing your machine.

Never use a machine that has a faulty muffler.

Regularly check that the muffler is securely attached to the 
machine.

If the muffler on your machine is fitted with a spark arrestor 
mesh this must be cleaned regularly. A blocked mesh will 
cause the engine to overheat and may lead to serious 
damage.

 

T

 

o ensure good cutting results it is important that the contact 

pressure between the blades is correct. The contact pressure 
is adjusted by turning the screws on the underside of the bar 
clockwise as far as they will go. Then turn the screws 
anticlockwise a 1/4 turn. Lock the screws using the locking nut 
on the top of the bar. Check that the screws are loose enough 
to allow the washers under the screw heads to slide sideways.

When the blades are correctly adjusted the play between the 
blades should be 0,2–0,4 mm, measured at the screws.

The edges of the blades are too hard to be filed. Dull blades 
should be sharpened using a grinder.

Replace the blades if they are bent or damaged.

 

The gear housing gets hot when the machine has been in 

 

use. To avoid burning yourself do not touch the gear housing.