Jonsered HTE2123 Manual De Usuario
English
– 9
ASSEMBLY
Fitting the main body
Connect the engine (A) to the tube (B) with four screws (C).
Connecting throttle cable and stop
switch wires
switch wires
1
Insert the throttle cable (A) through the carburettor bracket
(B), then screw the cable adjuster sleeve (C) into the
carburettor bracket fully.
(B), then screw the cable adjuster sleeve (C) into the
carburettor bracket fully.
2
Position the slotted fitting (D) on the carburettor so the
recessed hole (E) for the cable lug (F) is away from the
cable adjuster sleeve.
recessed hole (E) for the cable lug (F) is away from the
cable adjuster sleeve.
3
Rotate the carburettor throttle cam and slip the throttle
cable through the slot in the slotted fitting, making sure the
cable lug drops into the recessed hole.
cable through the slot in the slotted fitting, making sure the
cable lug drops into the recessed hole.
4
Operate the throttle trigger a few times to make sure that
it works correctly.
it works correctly.
5
Adjust the cable adjuster sleeve so the stop on the
carburettor throttle cam just contacts the throttle stop and
the cable position keep 1-2 mm play between the cable
lug and the slotted fitting when the throttle trigger is fully
depressed.
carburettor throttle cam just contacts the throttle stop and
the cable position keep 1-2 mm play between the cable
lug and the slotted fitting when the throttle trigger is fully
depressed.
6
When the throttle cable is adjusted correctly, tighten the
locking nut (G).
locking nut (G).
7
Plug the stop switch wires (H) into the matching
connectors from the engine. Note that wire polarity is not
important.
connectors from the engine. Note that wire polarity is not
important.
Fitting the handle
1
Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
must be mounted below the arrow on the shaft.
2
Attach the J-handle to the loop handle using the 4 screws,
as shown.
as shown.
3
Now make a final adjustment, with the machine hanging
from the harness, to obtain the most comfortable working
position. Tighten the screws.
from the harness, to obtain the most comfortable working
position. Tighten the screws.
A
B
C
1-2mm