Woodstock M1099 Manual De Usuario

-23-

A dead center can be used in the tailstock and lathe 
spindle to support workpieces. When used in this man-
ner, make sure to keep the dead center tip and workpiece 
lubricated to prevent tip galling. 

(%  Feed the quill out about 1" and insert the dead cen-

ter (

=`^li\)(). The mating tapers provide the lock-

ing fit.

)%  Move the tailstock into position and lock in place.

 

*%  Feed the quill into the workpiece. 

+%  Lock the quill into place once the dead center and 

the workpiece rotate together. The quill may need to 
be adjusted during operation. 

,%  To remove the dead center, retract the quill until
 

the dead center pops free.

(% DISCONNECT POWER TO THE LATHE!

)%  Remove the chuck from the spindle.

*%  Install the MT#4 dead center in the spindle.

+%  Attach the faceplate to the spindle, see =`^li\ )). 

Refer to 

Dflek`e^:_lZbXe[=XZ\gcXk\ on GX^\(- 

for details if required.

 

Efk\1 N_\elj`e^k_\[\X[Z\ek\i`ek_\jg`e[c\#
lj\XcXk_\[f^jfk_XkpfligXikn`ccifkXk\n`k_
k_\]XZ\gcXk\Xe[efkjg`efek_\[\X[Z\ek\ik`g%

=`^li\))% Faceplate and dead center 

setup.

=`^li\)(% Inserted dead center.