Bunn MCAA Manual De Usuario

16

8)  When the cycle has finished, empty the container. Repeat step 7 at least two more 

times to remove the solution from the tank.

9)  Clean the pod holder with a mild detergent and rinse thoroughly.

10)  Proceed to the “Cleaning The Sprayhead/Seal” section.

1)  Press the Power Switch into the off “O” position. 

2)  Unplug the brewer and allow it to cool down. (Minimum of 1 hour.)

3)  After the unit has been allowed to cool, remove the pod holder and set aside.

4)  Using your fingers, rotate the sprayhead/seal assembly 

clockwise until the sprayhead and seal are removed.

5)  Clean the sprayhead and seal with a mild detergent and rinse 

thoroughly.

6)  Using your fingers, rotate the sprayhead/seal assembly counter-clockwise until it is 

finger tight.

7)  Replace the pod holder.

8)  Plug in the brewer and press the Power Switch to restore power to the brewer.

If the sprayhead and seal are separated during removal or cleaning, they must be 

reassembled properly.
1)  Identify the top of the seal. The top of the seal that seats 

against the roof of the sprayhead ramp has a  rough ridge that 

can be felt by running your fingers across the surface of the 

seal. The bottom is smooth.

2)  Identify the top of the sprayhead. The top of the sprayhead 

has a star pattern and a threaded hole where the sprayhead 

attaches to the brewer. 

3)  While carefully stretching the seal, guide the sprayhead into 

the channel of the seal.  Make sure it is completely in the 

channel.

 

When properly assembled, the sprayhead will slide easily into 

the channel of the seal and will not cause any buckles in the surface 

of the seal. If the sprayhead seems to be difficult to seat, and you 

must stretch the seal more than a slight tug, the assembly is not 

together correctly.

Top

Top

P2953

P2953

P2953

P3015