Bunn 41343 Manual De Usuario

Page 13

AUTO  WARMER SHUT OFF (SETTING THE AUTO 

 

This function allows the warmers on the brewer to 

be programed automatically shut off after a set time.  

When the timer expires the batch lights on that side 

will begin to flash to indicate the warmer(s) have shut 

off.

NOTE: Flashing can be stopped by pressing any 

batch switch on the side activated, or by turning the 

warmer back on. Turning the warmer back on reacti-

vates the timer.

1.  Press and hold upper right hidden switch until the 

display reads 

UNITS. Press and release upper right 

hidden switch until the display reads WARMER 

OFF.

2. Using (-) and (+), set the amount of time the 

warmers are to operate.

3.  When finished, press DONE to store the programed 

time. The display should now read WARMER 

CONTROL?.

4.  Press and release the ON/OFF switch (either on 

DUAL brewers) located on the front switch panel 

to exit the AUTO WARMER function and return to 

the MAIN SCREEN.

WARMER OFF:  OFF

(-)      DONE      (+)

P3261

41343 120710

 

WARMER CONTROL?

 NO  DONE YES

  This function allows the heat intensity and warm 

time of the warmer(s) on the brewer to be adjusted.  

When the timer expires the batch lights on that side 

will begin to flash to indicate the warmer(s) have shut 

off.

NOTE: Flashing can be stopped by pressing any 

batch switch on the side activated, or by turning the 

warmer back on. Turning the warmer back on reacti-

vates the timer.

1.  Press and hold upper right hidden switch until the 

display reads UNITS. Press and release upper right 

hidden switch until the display reads WARMER 

CONTRL?.

2.  Press and release NO. The display will read FRESH 

3. Press YES to proceed. The display should now 

read 1st ON TIME on SINGLE brewers, (<

ON TIME on DUAL brewers). 

4. Using (-) and (+), set the amount of time the 

warmers are to operate.

5.  When finished, press the center program switch. 

The display should now read 1st ON POWER on 

SINGLE brewers (<

 1st ON POWER on DUAL 

brewers).

6. Using (-) and (+), set the percent of heat to be 

applied to the warmer.

7.  When finished, press the center program switch. 

The display should now read 2nd ON TIME on 

SINGLE brewers, (<

 2nd ON TIME on DUAL 

brewers).

8. Using (-) and (+), set the amount of time the 

warmers are to operate.

9.  When finished, press the center program switch. 

The display should now read 

2nd ON POWER on 

SINGLE brewers, (<

 2nd ON POWER on DUAL 

brewers).