DeLonghi ECAM26455 Manual De Usuario

Descargar
Página de 22
13
coffee buttons  (
or 
).
t
"UUIFFOEPGEFMJWFSZ UPJODSFBTFUIFRVBOUJUZPGDPòFF
in the cup, just press (within 3 seconds) one of the coffee 
buttons  (
or 
).
Once the coffee has been made, the appliance is ready to use 
again. 
 Please note!
t
7BSJPVTBMBSNNFTTBHFTDPVMECFEJTQMBZFEXIJMFVTJOH
the machine (fill tank, empty grounds container, etc.). 
Their meaning is explained in the section “Displayed 
messages” (page 20). 
t
'PSIPUUFSDPòFF TFFUIFTFDUJPOi5JQTGPSBIPUUFSDPòFFw
(page 12).
t
*GUIFDPòFFJTEFMJWFSFEBESPQBUBUJNF UPPXFBLBOE
not creamy enough or too cold, read the tips in the 
“Troubleshooting” section on page 21.
Making coffee using pre-ground coffee
 Important!   
t
/FWFSBEEQSFHSPVOEDPòFFXIFOUIFNBDIJOFJTPòPSJU
could spread through the inside of the machine and dirty 
it. 
 
This could damage the appliance.
t
/FWFSVTFNPSFUIBOMFWFMNFBTVSFPSJUDPVMEEJSUZUIF
inside of the coffee maker or block the funnel.
 Please note!
 
If you use pre-ground coffee, you can only make one cup 
of coffee at a time. 
1. Press 
the 
  button (fig. 9) until “Pre-ground” is 
displayed. 
2.   Open the beans container lid; then open the pre-ground 
coffee funnel lid by pushing on PUSH and, once released, 
open the lid. 
3.   Make sure the funnel is not blocked, then add one level 
measure of pre-ground coffee (fig. 17).
4.   Place a cup under the coffee spouts.
5.   Press the 1 cup coffee button 
 (fig. 11).  
6.   Preparation begins. The amount of coffee selected is 
displayed together with a progress bar which gradually 
fills as preparation progresses. 
 Please note!
If “Energy saving” mode is enabled, you may have to wait a few 
seconds before the first coffee is delivered.
MAKING DRINKS WITH MILK
 Please note!
t
5PBWPJEQSPEVDJOHNJMLXJUIQPPSGSPUIPSMBSHFCVCCMFT
always clean the milk container lid and hot water nozzle 
as described in the section “Cleaning the milk container” 
on pages 14 and 17. 
Filling and attaching the milk container
1.  Remove the lid (fig. 18); 
 'JMMUIFNJMLDPOUBJOFSXJUIBTVóDJFOURVBOUJUZPGNJML
not exceeding the MAX level marked on the container (fig. 
19).  Each mark on the side of the container corresponds 
to 100 ml of milk. 
 Please note!
t 'PSBEFOTFSNPSFFWFOGSPUI ZPVTIPVMEVTFTLJNNFE
or partially skimmed milk at refrigerator temperature 
(about 5°C).  
t
*Gi&OFSHZ4BWJOHwNPEFJTFOBCMFE ZPVNBZIBWFUPXBJU
a few seconds before the first drink is delivered.
3.  Make sure the milk intake tube is correctly inserted in the 
bottom of the milk container lid (fig. 20).
4.   Place the lid back on the milk container. 
5.   Remove the hot water spout from the nozzle.
6.   Attach the container to the nozzle and push as far as it 
will go (fig. 21). The machine emits a beep (if the beep 
function is enabled).
 1MBDFBTVóDJFOUMZMBSHFDVQVOEFSUIFDPòFFBOEGSPUIFE
milk spouts. Adjust the length of the milk spout. To move 
it nearer the cup, simply pull it downwards (fig. 22). 
8.   Follow the instructions below for each function. 
Adjusting the amount of froth
Turn the froth adjustment dial on the milk container lid to 
adjust the amount of froth on the milk delivered while making 
drinks with milk.    
Dial 
position 
Description
Recommended for…
No froth
FLAT WHITE/ 
HOT MILK
Min. froth
LATTE 
Max. froth
CAPPUCCINO