NuTone 761WHNT Manual De Usuario

*

 Additional framing must be a 2x6 (minimum height), at least 9-inches long.

*

*

INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1.  Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer at the address

or telephone number listed in the warranty.

2.  Before servicing or cleaning unit, switch power off at service

panel and lock the service disconnecting means to prevent

power from being switched on accidentally. When the service

disconnecting  means  cannot  be  locked,  securely  fasten

a prominent warning device, such as a tag, to the service

panel.

3.  Installation  work  and  electrical  wiring  must  be  done  by  a

qualified person(s) in accordance with all applicable codes

and standards, including fire-rated construction  codes and

standards.

4.  Sufficient air is needed for proper combustion and exhausting

of gases through the flue (chimney) of fuel burning equip-

ment to prevent backdrafting. Follow the heating equipment

manufacturer’s guideline and safety standards such as those

published by the National Fire Protection Association (NFPA),

and the American Society for Heating, Refrigeration and Air

Conditioning Engineers (ASHRAE), and the local code authori-

ties.

5.  When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

6.  Ducted fans must always be vented to the outdoors.
7.  NEVER place a switch where it can be reached from a tub or

shower.

8.  This unit must be grounded.
9.  This unit is U.L. listed. Type I.C. inherently protected.

1.  For general ventilating use only. Do not use to exhaust hazard-

ous or explosive materials and vapors.

2.  This product is designed for installation in FLAT CEILINGS

ONLY. Do not mount this product in a wall.

3.  The light fixture assembly must be mounted to the fan housing

assembly included with this product. Do not mount the light

fixture assembly to a wiring outlet box.

4.  To avoid motor bearing damage and noisy and/or unbalanced

impellers, keep drywall spray, construction dust, etc. off power

unit.

5.  Please read specification label on product for further informa-

tion and requirements.

The unit will operate 

most quietly and 

efficiently when 

located where the 

shortest possible 

duct run and 

minimum number 

of elbows will be 

needed.
Use a roof cap or 

wall cap that has a 

built-in damper to 

reduce backdrafts.
Plan to supply the 

unit with proper 

line voltage and 

appropriate power 

cable.

4-in. ROUnD

ELBOW(S) 

*

4-in.

ROUnD

DUCT 

*

WALL CAP 

*

*

 Purchase

   separately

inSULATiOn

(Can be placed 

around and over 

fan housing.)

fAn

hOUSing