Continental Refrigerator 102004 Manual De Usuario

10

During installation, it may become necessary to remove the cabinet doors to 
facilitate passage through narrow doorways or hallways. To remove a door, pry 
off all hinge covers using a sharp tool or knife (see figure 5). Swing the door to 
the open-door position (90°) and carefully lift the door upward, removing the 
door from the hinge bodies. If it is necessary to remove the hinge bodies from 
the cabinet face, be extremely careful not to lose the light switch pin located inside 
all top hinge bodies. To reinstall the door, reverse the above procedure.

All doors have been aligned at the factory, however vibration during transportation 
may cause doors to shift and realignment may be necessary. If the door(s) require
realignment, proceed as follows:

1. Pry off all hinge covers using a sharp tool or knife.
2. For each door, loosen the screws which secure the hinge bodies to the 

cabinet face and slide the door into alignment. Hold the door firmly in place 
and tighten all screws securely.

If the door gasket(s) do not seal properly to the cabinet face and there are gaps
between the gasket and the face on the hinge edge, proceed as follows:

1. For each door, loosen all screws which are directed into the edge of the 

door and push the door towards the cabinet eliminating the gap. Hold the 
door firmly in place and tighten all screws securely.

2. Replace all snap-on hinge covers.