Continental Refrigerator 102004 Manual De Usuario

8

Your roll-in model comes with one cart ramp per door opening. To install the ramp(s),
simply open the cabinet door and position the ramp slots onto the screws located
along the cabinet bottom front. If the door wiper rubs along the ramp to the extreme
where the door will not self-close, you will need to adjust the door (see “door adjust-
ment” section) or level the cabinet as explained above.

It is extremely important that your new reach-in or roll-in model is

perfectly level for proper operation. If it is not level, the following adverse conditions
will become apparent:

1. The door(s) will not be properly aligned and consequently will not provide a 

good seal. Roll-in door wiper(s) may bind.

2. Your model will run excessively due to improper door seal(s).
3. An excessive amount of ice will accumulate inside the cabinet, around the 

door opening(s) and especially on the finned evaporator coil. If allowed to 
continue, ice will eventually block the coil and the model will fail. This will 
result in the loss of all food stored within the cabinet.

4. Defrost water will fail to drain properly and will overflow the evaporator coil 

drain pan and into the cabinet of both refrigerator and freezer models.

If you wish to install casters on your new reach-in model, follow the steps above 
for “installing legs” to install the casters, making sure again that the casters are 
tightened extremely well (see figure 3). If the casters are not installed tightly, the 
cabinet will sway or rock with each opening or closing of the doors, possibly causing
damage to the case bottom.

To assure that your cabinet is level, caster cups must be installed under the casters
which need leveling. Caster cups are not provided with your new model but can be
purchased at most hardware or furniture stores. Do not attempt to level casters by
unscrewing them from the case bottom as this will cause damage to the cabinet 
bottom and leg hole threads, voiding all warranties.