Furuno FCR-28x9 Manual De Usuario

14.  HOW TO MONITOR ROUTES

In the Voyage navigation mode, click the [Route] and [Unselect] buttons. 

You can specify what parts of the monitored route to display. Click the [DISP], [SET] 
and [Symbol DISP] buttons on the InstantAccess bar.

z

When you choose a route for monitoring, the messages shown below appear, on the 
[Select Route] dialog box or in a message window, when a route cannot be opened 
for monitoring.
•  "Impossible turn at waypoint XX" (XX=waypoint no.). Geometry of the route makes 

it impossible for the ship to accomplish a turn. Modify the route to make the turn 
possible.

•  "Unchecked / Check condition differs". The route has not been checked. Check the 

route, on the [Alert Parameters] page.

•  "Monitored in the NAVI mode". The route is currently being monitored. 
•  "More than one WPT needed". The route has only one waypoint. Add more way-

points to the route.

•  "Route monitoring cannot be started. Please check ship’s position and conditions." 

Click the [OK] button to close the message. Check ship’s position and conditions 
of the route.

z

If you have small-scale chart(s) on display that have the whole eastern/western (0-
180°E/0-180°W) hemisphere and a part of the other hemisphere on display, there is 
a limitation to display a route. To avoid this, set chart center so that the whole eastern/
western hemisphere is not on the screen.

z

Six routes, one active and five plan, can be shown simultaneously in the Voyage nav-
igation mode.

z

If, in the radar mode, route monitoring is stopped, the alert 691 "RM Stop - Exceed 
Max XTE", 692 "RM Stop - Disconnect Sensors", or 693 "RM Stop - Other Causes" 
appears. If this occurs, switch to the Chart for Radar mode. The pop-up shown below 
appears. Click the OK button. Find the reason why route monitoring was stopped and 
then restart route monitoring.

z

Route monitoring is stopped and an alert is displayed when the GPS position is lost. 
Restore GPS position then restart route monitoring.