Schneider Electric PM5100 Manual De Usuario

32

© 2014 Schneider Electric All Rights Reserved

Chapter 4—Front panel display and meter setup

PowerLogic™  PM5100 series user guide

The meter’s front panel buttons and display screen allow you to navigate and configure 
the meter’s setup parameters. The following illustration shows one of the meter setup 
screens.

In this example, the down arrow ( ) indicates there are more parameters below the 
selected option ( ). Press the down arrow button to display additional parameters. The 
down arrow disappears when the last item in the list is selected, and there are no more 
parameters to display.

Meter configuration can be performed directly through the front panel buttons or 
remotely through software. This section contains instructions on setting up the meter 
using the front panel.

•

See “Remote Meter Setup” on page 41 for remote meter setup details.

Proper configuration of the meter’s basic setup parameters is essential for accurate 
measurement and calculations. Use the Basic Setup screen to define the electrical 
power system that the meter is monitoring.

If standard (1-sec) alarms have been configured and you make subsequent changes to 
the meter’s basic setup, all alarms are disabled to prevent undesired alarm operation. 
After saving the changes, confirm all configured standard alarm settings are still valid, 
reconfigure them as required, and re-enable the alarms.

After modifying any basic setup parameter:
• Verify all standard alarms settings are correct and make adjustments as necessary.
• Re-enable all configured alarms.