Garmin G1000H Manual De Usuario
190-01255-00 Rev. B
Garmin G1000H
™
Pilot’s Guide for the Bell 407GX
363
HAZARD AVOIDANCE
3)
Turn the Range knob to set the range to 2/6 nm to allow for the full test pattern to be displayed.
4)
Select the TEST Softkey.
Or:
1)
1)
Press the MENU Key and turn the small
FMS
knob
to select ‘Test Mode’.
2)
Press the ENT Key.
TA at 9 o’clock,
Distance 2.0
nm, 200’ Below,
Climbing
Non-Threat
Traffic at
11 o’clock,
Distance 3.6
nm, 1000’
Above, Level
Proximity
Traffic at
1 o’clock,
Distance
3.6 nm,
1000’ Below,
Descending
Operating
Mode
Test Mode
Annunciation
Figure 6-94 System Test in Progress with Test Pattern
OPERATION
After power-up, the traffic system is in Standby Mode. The system must be in Operating Mode for traffic to
be displayed and for TAs to be issued.
Selecting the OPERATE Softkey allows the system to switch from Standby Mode to Operating Mode as
necessary. Selecting the STANDBY Softkey forces the unit into Standby Mode.
Switching from operating mode to standby mode:
On
the Traffic Page, select the STANDBY Softkey
Or:
1)
1)
Press the MENU Key and turn the small
FMS
knob
to select ‘Standby Mode’.
2)
Press the ENT Key.