Schneider Electric Altivar 12 Manual De Usuario
BBV28581 05/2010
9
Steps for setting up (also refer to Quick Start)
1. Receive and inspect the drive
v
Check that the part number printed on the label is the same as that on the
purchase order.
purchase order.
v
Remove the Altivar from its packaging and check that it has not been damaged
in transit.
in transit.
2. Check the line voltage
v
Check that the line voltage is compatible with the voltage
range of the drive (page
range of the drive (page
3. Mount the drive
v
Mount the drive in accordance with the instructions
in this document (page
in this document (page
).
v
Install any options required.
Steps 2 to 4 must
be performed with
the power off.
be performed with
the power off.
4. Wire the drive
(page
)
v
Connect the motor, ensuring that its
connections correspond to the voltage.
connections correspond to the voltage.
v
Connect the line supply, after making
sure that the power is off.
sure that the power is off.
v
Connect the control part.
5. Configure the drive
(page
v
Apply input power to the drive but
do not give a run command.
do not give a run command.
v
Set the motor parameters
(in Conf mode) only if the factory
configuration of the drive is not
suitable.
(in Conf mode) only if the factory
configuration of the drive is not
suitable.
v
Perform auto-tuning.
6. Start