3com S24x Manual De Usuario
Maintenance
4-3
Removing/Replacing Top Cover
Removing/Replacing Top Cover
Introduction
You must remove the top cover to access the motherboard and all I/O cards, the
power supply, and the fan.
power supply, and the fan.
Removing the
Cover
Cover
Perform these steps to remove the top cover of the PathBuilder S24x, 26x, and 27x
switch:
switch:
Step
Action
1
Verify that the power is OFF.
2
Remove the six screws from the back of the chassis (Figure 4-1 ).
3
Pull the cover toward the rear of the unit (approximately 1/4 inch).
4
Lift up to release from the sliding clips.
Note
Be sure not to damage spring clips on chassis.