Bradford-White Corp Convection Heater Manual De Usuario

 

6

 

 
This water heater MUST NOT be installed in any location where gasoline 
or flammable vapors are likely to be present, unless the installation is 
such to eliminate the probable ignition of gasoline or flammable vapors.  
 
Water heaters in residential garages must be installed and located, or 
protected, to avoid physical damage.  For other installations refer to 
local codes.  In the absence of local codes, the water heater must be 
installed in compliance with the National Fuel Gas Code, (ANSI Z223.1- 
Latest Edition), or in Canada CAN/CGA B149.1 Natural Gas Installation 
Code (Latest Edition) or CAN/CGA B149.2 Propane Installation Code 
(Latest Edition). 
  
The location of this water heater is of the utmost importance. Before installing 
this water heater read the Installation section of these instructions. After reading 
these Installation and Operating Instructions, select a location for the water 
heater where the floor is level and is easily accessible to gas and water supply 
lines. DO NOT locate the water heater where water lines could be 
subjected to freezing temperatures.  Make sure the cold water pipes are 
not located directly above the gas control so that condensate during 
humid weather does not drip on the controls. 

 

Water heaters are heat producing appliances. To avoid damage or injury 
there shall be no materials stored against the water heater or vent-air intake 
system and proper care shall be taken to avoid unnecessary contact 
(especially by children) with the water heater and vent-air intake components. 
UNDER NO CIRCUMSTANCES SHALL FLAMMABLE MATERIALS, SUCH 
AS GASOLINE OR PAINT THINNER BE USED OR STORED IN THE 
VICINITY OF THIS WATER HEATER, VENT-AIR INTAKE SYSTEM OR IN 
ANY LOCATION FROM WHICH FUMES COULD REACH THE WATER 
HEATER OR VENT-AIR INTAKE SYSTEM.