Bradford-White Corp PE2XR504T*F(BN,SX) Manual De Usuario

 Page 25 

Gas Control Removal From Thermal Well 
Following the steps below allow for the removal of the gas control from the thermal well 
without removing the thermal well from the tank. 

Step 1. 

Move the gas control power switch to the “OFF” 

position.

Step 2. 

Unplug the water heater and Accessory Module from the 

wall outlet. 

Step 3. 

Turn off the gas supply to the water heater and disconnect 

the gas piping from the gas control. 
Step 4. 

Disconnect the pilot tube 

using a 7/16” wrench and the main burner
feedline with a 3/4” wrench from the gas 
control.

Step 5. 

Disconnect the wire harnesses and spark igniter/

flame sense wire from the gas control.

Step 6. 

Using the gas control service tool, p/n

239-45991-00, available from your BWC parts supplier, insert 
the tool into the back of the gas control. 

Gas control power 

switch 

Pilot and main 

feedlines 

Spark igniter/flame 

sensor wire 

Gas control

Gas control service 

tool

Water heater power cord and 

Accessory Module transformer 

25