Guardian Technologies 004702-0 Manual De Usuario

  

35

Apply electrical loads equal to about 75 to 100 per-
cent of the unit's rated wattage/amperage capacity.

Let the unit run at least 30 minutes with load applied. 
During this part of the test, check that the unit is not 
running excessively hot and that adequate cooling 
airflow is available. Do not allow the unit to overheat 
during prolonged operation.

NOTE:

The generator engine is equipped with a high tem-
perature switch. The switch has normally open 
(N.O.) contacts. When the engine temperature is 
too high, switch contacts close, and the engine 
shuts down automatically.

THE MANUFACTURER RECOMMENDS THAT THE 
GENERATOR BE TESTED FOR ADEQUATE COOL-
ING.

❑  Generator is properly located.
❑  Generator is properly supported.
❑  Generator is properly restrained.

❑  Compartment construction is proper.
❑  Holes/Openings are vapor-sealed.
❑  Compartment size is correct.
❑  Compartment is vapor-sealed.
❑  Sound insulation is correct.
❑  Floor cutouts are properly completed.

❑   Airflow is adequate.
❑   Air inlet opening is correct.
❑   Compensate for restrictions.
❑   Check that installation has been tested.

❑  Fuel tank complies with all applicable codes.
❑   Fuel system is properly installed and checked for 

leaks.

‹

‹

‹

‹

❑   Fuel system is properly installed and checked for 

leaks.

❑   Pressure at regulator inlet is correct.
❑   Rated flow of primary regulator is correct.
❑   All parts are properly installed.
❑   Fuel system is properly tested/adjusted.

❑   Exhaust system complies with all applicable 

codes.

❑   Exhaust system is properly and safely installed.

❑   Connections comply with local code requirements 

and all National Electrical Codes.

❑  Junction box is properly installed.
❑  Wiring meets all standards.
❑   All connections are correct.
❑   Conduit is properly installed and sealed.
❑  Generator is properly bonded to the vehicle.

❑  Recommended battery is installed.
❑  Recommended cables are installed.
❑  Cables are clean and tight.
❑  Cables are connected properly.
❑  Proper ventilation is provided.
❑   Terminals are coated with anti-corrosion grease, 

and terminal covers are positioned.

❑   Check that remote start/stop panels (if used) are  

installed properly.

❑   Check that hourmeter kit (if used) is installed 

properly.

❑   Check that any other options and accessories (if 

used) are installed properly.

❑  Check that all tests are completed properly.

‹

‹

‹

‹

‹

‹