NEC NP300 Guía Del Usuario
4
4. Convenient Features
Changing Lamp Mode
This feature enables you to select two brightness modes of the lamp:
Normal and Eco modes. The lamp life can be extended by using the Eco mode.
Normal and Eco modes. The lamp life can be extended by using the Eco mode.
To change to the [ECO] mode, do the following:
1. Press the LAMP MODE button on the remote control to display [LAMP MODE] screen.
2. Use the SELECT
1. Press the LAMP MODE button on the remote control to display [LAMP MODE] screen.
2. Use the SELECT
or button to select [ECO] mode.
3. Press the ENTER button.
To change from [ECO] to [NORMAL], Go back to Step 2 and select [NORMAL]. Repeat Step 3.
NOTE:
• The LAMP MODE can be changed by using the menu.
Select [SETUP]
• The LAMP MODE can be changed by using the menu.
Select [SETUP]
→ [GENERAL] → [LAMP MODE].
• The lamp life remaining and lamp hours used can be checked in [USAGE TIME]. Select [INFO.]
→[USAGE TIME].
• The projector is always in [NORMAL] for one minute after the lamp is turned on and while the POWER indicator is blinking green.
The lamp condition will not be affected even when [LAMP MODE] is changed.
• After a lapse of 3 minutes from when the projector displays a blue, black or logo screen, [LAMP MODE] will automatically switch
to [ECO]. The projector will return to the [NORMAL] once a signal is accepted.
• If the projector is overheated in [NORMAL] mode, there may be a case where the [LAMP MODE] automatically changes to [ECO]
mode to protect the projector. When the projector is in [ECO] mode, the picture brightness decreases. When the projector comes
back to normal temperature, the [LAMP MODE] returns to [NORMAL] mode.
back to normal temperature, the [LAMP MODE] returns to [NORMAL] mode.
Thermometer symbol [ ] indicates the lamp mode is automatically set to [ECO] mode because the internal temperature is too
high.
2. Press the SELECT
button.
The area of the magnified image will be moved
3. Press the MAGNIFY (-) button.
Each time the MAGNIFY (-) button is pressed, the image is reduced.
Each time the MAGNIFY (-) button is pressed, the image is reduced.
NOTE:
• The image will be enlarged or reduced at the center of the screen.
• Displaying the menu will cancel the current magnification.
• The image will be enlarged or reduced at the center of the screen.
• Displaying the menu will cancel the current magnification.
ENTER
EXIT
MENU
UP
MAGNIFY
PAGE
OFF
POWER
ON
PIC-MUTE
DOWN
Lamp Mode
NORMAL
ECO
Description
This is the default setting (100%
Brightness).
Brightness).
Select this mode to increase the
lamp life (approx. 70% Brightness
on NP600/NP500W/NP600S/
NP500WS and approx. 80% Bright-
ness on NP500/NP400/NP300).
lamp life (approx. 70% Brightness
on NP600/NP500W/NP600S/
NP500WS and approx. 80% Bright-
ness on NP500/NP400/NP300).
Status of LAMP indicator
Off
Steady Green light
STATUS
LAMP
STATUS
LAMP