Enterasys 6000 Guía Del Usuario
7-12
FRX/FRM 3. 3 User G uide, Rev 04
Configuring a Dial Port
If the port will be connected to an auto-dial modem, configure the parameters on the
following screen.
following screen.
Figure 7-4 X.25 Dial Port Parameters
Dial Port Parameters
Dial Support
specifies whether this port is connected to a dial modem and, if so, whether connec-
tions will be initiated through dial-in or dial-out calls. (Signaling differences prevent
configuration for both dial-in and dial-out on the same port.)
tions will be initiated through dial-in or dial-out calls. (Signaling differences prevent
configuration for both dial-in and dial-out on the same port.)
A dial-out port will establish a link only when an outgoing X.25 call is placed, at
which time the port will raise DTR and the attached modem will dial a stored number
to a remote modem to establish an X.25 connection. A dial-in port will establish a link
only when a call is received.
which time the port will raise DTR and the attached modem will dial a stored number
to a remote modem to establish an X.25 connection. A dial-in port will establish a link
only when a call is received.
If this port is configured as a network trunk, the value for
Dial Support
must be
None
.
Table 7-3 X.25 Port Dial Parameters
Parameter
Valid Values
Default Value
Dial Support
None, Dialout, Di ali n
None
Inactivi ty Timer
(minutes)
1–30
5
Disconnect Ti mer
(seconds)
1–255
5
Line Setup Timer
(seconds)
1–255
5
Node N ame= nod exyz
X.25 Port Parameters (screen 6 of 6)
Databas e
System Memory
A D ial S upp ort
Dial In
Dial In
B I nactivity Timer (minutes)
5
5
C D is con nect Timer (s ec)
5
5
D Line S etu p Timer (sec)
1
1
Option: