Conairphone cid154 Manual De Propietario
CONGRATULATIONS!
You have purchased a CID154, Call Waiting**/Caller ID* Sport
Telephone manufactured to the highest standards of
Conairphone
Telephone manufactured to the highest standards of
Conairphone
TM
. Before installing and operating, be sure to read
this manual.
GENERAL INFORMATION
UNPACKING
This package contains:
• CID154 Call Waiting**/Caller ID* Sport Telephone
• Owner’s Manual
• Fully Modular Coil Cord
• Fully Modular Telephone Line Cord
• Quick Setup Guide
• Important Notice
• Two (2) Memory Index Labels
• Warranty Card
• CID154 Call Waiting**/Caller ID* Sport Telephone
• Owner’s Manual
• Fully Modular Coil Cord
• Fully Modular Telephone Line Cord
• Quick Setup Guide
• Important Notice
• Two (2) Memory Index Labels
• Warranty Card
If anything is missing or damaged, contact the place of purchase.
Keep the packaging to transport telephone.
Keep the packaging to transport telephone.
For your reference, keep a record of the date purchased.
Please save the sales receipt for the warranty reference.
Please save the sales receipt for the warranty reference.
Date of Purchase ___________________________
4
5
6
1. Receiver
2. Tone/Pulse
3. LCD Display
4. Review (up) / (down)
5. Key Pad
6. Redial
7. Flash
8. Mouth Piece
(Transmitter)
9. New Call LED
10. Receiver Volume Control
11. Backlit LED
12. Call Back
13. Erase
14. Comfort Grips
15. Store
16. Memory
17. Telephone Line Jack
18. Handset Jack
19. Ringer Hi/Lo/Off
INSTALLATION INSTRUCTIONS
Follow these precautions:
a. Never install telephone wiring during a lightning storm.
b. Never install telephone jacks in wet locations unless the jack
b. Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
c. Never touch uninsulated telephone wires or terminals unless
the incoming telephone line has been disconnected at the
network interface.
network interface.
d. Use caution when installing or modifying telephone lines.
INSTALLATION
Choose Your Location
Your unit must be placed on a hard flat surface and connected
to the telephone wall jack. Allow at least one inch to the rear
and four inches above the unit for ventilation.
to the telephone wall jack. Allow at least one inch to the rear
and four inches above the unit for ventilation.
To Install 4 AAA Batteries
Batteries are required for the Caller ID functions and Telephone
operations of the unit.
operations of the unit.
To install batteries
1. Open the battery door by pulling
back the latch.
2. Install four (4) AAA alkaline
batteries (not included).
3. Snap the battery door back into
place.
To replace batteries
The CID154 will signal you when the batteries become weak
and need replacement. Once battery power has been sufficiently
drained, the CID154 will appear the
and need replacement. Once battery power has been sufficiently
drained, the CID154 will appear the
icon on the LCD display.
Replace the AAA batteries with four (4) fresh ones, and keep
the line cord plugged in between the phone and wall outlet in
order to maintain the Caller ID and Speed Dialing memories. If
you do not install fresh batteries within 2 minutes, your Caller ID
and telephone memory information may be lost.
the line cord plugged in between the phone and wall outlet in
order to maintain the Caller ID and Speed Dialing memories. If
you do not install fresh batteries within 2 minutes, your Caller ID
and telephone memory information may be lost.
LOCATION OF CONTROLS
Handset
Cradle (rear)
1
2
3
3
4
5
6
7
7
8
10
12
13
13
14
15
16
9
17
18
11
19