Escient taurus Guía Del Usuario

FIREABALL REMOTE CONTROL GUIDE WD046-1-2 

4/30/2007

 

Every FireBall is preset from the factory to operate from the FB1 source button, however, the 
FireBall can be configured to use any one of the four source buttons using the on screen Setup 
menus. This is useful when there are multiple FireBalls installed at the same location, so all 
FireBalls don’t respond to the same IR commands. Use the following steps to change which 
source button (FB1, FB2, FB3, or FB4) each FireBall will listen for commands from: 
 

ƒ  Press the Setup key on the remote to display the FireBall setup menu. 
ƒ  Highlight and Select the Utilities menu item. 
ƒ  Highlight and Select the IR Remote Control menu item. 
ƒ  Highlight and Select which source button to use to control this FireBall. 
ƒ  Press the new source button on your remote to reconfigure the remote and confirm the 

change by selecting the OK button on screen. 

 
Repeat these steps for each FireBall in your system, selecting a different FB button for each. 

 

The FB1, FB2, FB3, and FB4 source buttons are preprogrammed at the factory with the 
correct codes to control four FireBalls.  If you changed these buttons to control other devices, 
you will have to reset the FB Source buttons back to the original codes in order to control 
FireBalls again. Use the following steps to program these buttons back to their factory states: 
 

ƒ  Press the FB1, FB2, FB3, or FB4 source button to be re-programmed. 
ƒ  Press & Hold the “Code Set” button on the remote until the LED flashes twice. 
ƒ  Enter the factory reset code which corresponds to the FB button being reset: 

6640 Intech Blvd. Suite 250   Indianapolis, IN 46278   317.616.6789 phone   317.616.6790 fax   www.escient.com