Quantum sdlt 220 Guía Del Usuario
SDLT 220 and SDLT 320 Product Manual
CHAPTER 4: Installing Your Tape Drive
81-85002-01
March 2004
4-21
4.4
Configuring and Installing a Tabletop
Drive
Drive
This section provides instructions for configuring and installing the SDLT tabletop
drive.
drive.
4.4.1 Configuring the Drive
shows the location of the controls and connectors for the tabletop drive.
This model tape drive is normally configured to meet customer specifications
before leaving the factory, so should not require any internal configuration changes
on-site.
before leaving the factory, so should not require any internal configuration changes
on-site.
Figure 4-7.
Back Panel of the Tabletop Model
SCSI ID The SCSI ID default for the tabletop drive is set to 3; the drive can be
configured for SCSI ID addresses that range from 0 to 15 using the SCSI ID
pushbutton. Press the button above or below the ID number display to set the
configured for SCSI ID addresses that range from 0 to 15 using the SCSI ID
pushbutton. Press the button above or below the ID number display to set the