Enterasys ssr-atm29-02 Guía Del Usuario
CoreWatch Users Guide
133
Chapter 9: Configuring Unicast Routing on the SSR
4.
Double-click the IP Unicast Routing object and then double-click the RIP Routing
object. Double-click the RIP Source Gateways object.
object. Double-click the RIP Source Gateways object.
5.
Click the Configure New RIP Source Gateway object.
6.
In the RIP Source Gateway dialog box that appears, enter the IP address or host name
of a router that you want to send RIP updates rather than using broadcast or multicast
messages.
of a router that you want to send RIP updates rather than using broadcast or multicast
messages.
7.
Click OK.
Configuration Expert adds the source gateway to the list of those found in the RIP
Source Gateways object.
Source Gateways object.
8.
through
until you create the desired list of source gateways.
What to Do Next
As discussed in the following list, what you do after configuring IP interfaces for unicast
routing depends on your network environment and whether you want to control traffic or
set security.
routing depends on your network environment and whether you want to control traffic or
set security.
•
If you are planning to implement multicast routing on the SSR, configure IP interfaces
for multicast routing as discussed in
for multicast routing as discussed in
.
•
If you are not using multicast routing but you will be using IPX, see
.
•
If you do not need to configure the SSR for multicast routing or IPX, you can control
traffic as discussed in
traffic as discussed in
. You can
also set up security as discussed in
. Both tasks are optional.