ZyXEL nbg-4615 Guía Del Usuario
Chapter 12 WISP Mode
NBG4615 User’s Guide
107
12.5.2 WPA(2)-PSK
Use this screen if the access point to which you want to connect uses WPA(2)-PSK
security mode.
security mode.
Figure 70 WPA-PSK/WPA2-PSK (WISP)
The following table describes the labels in this screen.
Hex
Select this option in order to enter hexadecimal characters as a WEP key.
The preceding "0x", that identifies a hexadecimal key, is entered
automatically.
automatically.
Key 1 to Key
4
4
The WEP keys are used to encrypt data. Both the NBG4615 and the
wireless stations must use the same WEP key for data transmission.
wireless stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10
hexadecimal characters ("0-9", "A-F").
hexadecimal characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26
hexadecimal characters ("0-9", "A-F").
hexadecimal characters ("0-9", "A-F").
You must configure at least one key, only one key can be activated at any
one time. The default key is key 1.
one time. The default key is key 1.
Apply
Click Apply to save your changes back to the NBG4615.
Cancel
Click Cancel to reload the previous configuration for this screen.
Table 38 WEP (WISP) (continued)
LABEL
DESCRIPTION
Table 39 WPA-PSK/WPA2-PSK (WISP)
LABEL
DESCRIPTION
WISP Parameters
SSID
SSID
Enter the name of the access point to which you are connecting.
Channel
Selection
Selection
The range of radio frequencies used by IEEE 802.11b/g/n wireless
devices is called a channel. The device will automatically select the
channel with the least interference.
devices is called a channel. The device will automatically select the
channel with the least interference.
Security Mode
Select WPA-PSK or WPA2-PSK to enable data encryption.
Encryption Type Select the type of wireless encryption employed by the access point to
which you want to connect.