ZyXEL nbg-4615 사용자 가이드

 Chapter 12 WISP Mode

NBG4615 User’s Guide

Use this screen if the access point to which you want to connect uses WPA(2)-PSK 
security mode.

Figure 70   WPA-PSK/WPA2-PSK (WISP)

The following table describes the labels in this screen. 

Hex

Select this option in order to enter hexadecimal characters as a WEP key. 

The preceding "0x", that identifies a hexadecimal key, is entered 
automatically.

Key 1 to Key 
4

The WEP keys are used to encrypt data. Both the NBG4615 and the 
wireless stations must use the same WEP key for data transmission.

If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 
hexadecimal characters ("0-9", "A-F").

If you chose 128-bit WEP, then enter 13 ASCII characters or 26 
hexadecimal characters ("0-9", "A-F"). 

You must configure at least one key, only one key can be activated at any 
one time. The default key is key 1.

Apply

Click Apply to save your changes back to the NBG4615.

Cancel

Click Cancel to reload the previous configuration for this screen.

Table 38   WEP (WISP) (continued)

Table 39   WPA-PSK/WPA2-PSK (WISP)

WISP Parameters
SSID

Enter the name of the access point to which you are connecting.

Channel 
Selection

The range of radio frequencies used by IEEE 802.11b/g/n wireless 
devices is called a channel. The device will automatically select the 
channel with the least interference.

Security Mode

Select WPA-PSK or WPA2-PSK to enable data encryption.

Encryption Type Select the type of wireless encryption employed by the access point to 

which you want to connect.