ZyXEL p-660hwp Notas De La Versión
ZyXEL Confidential
340APD2C0.docdoc
6.
[Feature Enhance]: Every PVC’s MTU size can be changed separately ( in CLI “wan node
mtu” and GUI ).
mtu” and GUI ).
7.
[Feature Enhance]: Show all connections status in Web GUI
8.
[Feature Enhance]: Modify CI command to map Powerline into Triple Play Group by “ sys
tripleplay portbase groupset [groupid] [LAN |PVC] [index] [WLAN] [PWR] “.
tripleplay portbase groupset [groupid] [LAN |PVC] [index] [WLAN] [PWR] “.
9.
[Feature Enhance]:
Hardware version (in bootbase) has been changed from “00” to
“01”, and HW version range (in mmct) has been changed from “2 0 0” to “2 0 1”. So
old board (use old bootbase) can use new RAS code, but new board (use new bootbase)
can’t load old RAS code.
old board (use old bootbase) can use new RAS code, but new board (use new bootbase)
can’t load old RAS code.
10.
[Bug Fix]: Simultaneous upload/download bug. It reduces Download speed from 20Mbps
to 3-4 Mbps when you start simultaneous upload and download.
to 3-4 Mbps when you start simultaneous upload and download.
11.
[Bug Fix]: DNS servers have to be taken from 1-st PVC.
12.
[Bug Fix]: Can’t access internet by wireless when using Triple Play for IPTV.
13.
[Bug Fix]: IGMP snooping is not saved in rom-file and disappears upon device reboot
14.
[Bug Fix]: If a DHCP OFFER packet doesn’t assign default gateway, device will refuse to
work with it until it was fixed.
work with it until it was fixed.
15.
[Bug Fix]: Static route configuration: don’t check for gateway availability when configuring
a route since it makes impossible to pre-configure the device. Also, all routes must work
upon device reboot.
a route since it makes impossible to pre-configure the device. Also, all routes must work
upon device reboot.
16.
[Bug Fix]: Show last CLI command by “Up arrow” key instead of moving cursor up when
connecting by telnet
connecting by telnet
17.
[Bug Fix]: DNS issue: when accessing http://zyxel.* leads to web GUI.
18.
[Bug Fix]: Enable Triple Play: LAN PC can't send any file to WLAN PC
19.
[Bug Fix]: Fix triple-play throughput issue. the throughput is low when tripleplay enable
and only one route mode pvc exist.
and only one route mode pvc exist.
20.
[Bug Fix]: Fix AnyIP issue: it should work only on those Eth ports that are mapped to
routing PVC.
routing PVC.
21.
[Bug Fix]: Fix PADI issue. when PPPoE session is initializing, device should not send
PADI packets to lan ports.
PADI packets to lan ports.
22.
[Bug Fix]: Let wireless security to be configured by “wlan ieee8021x…” commands to
have the unified commands in all devices
have the unified commands in all devices
.
23.
[Bug Fix]:
Exception issue: when device work in full load (DSL, Homeplug, Ethernet
and wireless all enabled), device may go crash and reboot.
24.
[Bug Fix]:
DSL LED Blinking issue: when baud rate set as 115200, DSL LED will
blink even the phone cable is unplugged
Modifications in V3.40(APD.1)C0 | 7/30/2007
1. Change to FCS.
1. Change to FCS.
Modifications in V3.40(APD.1)b1 | 7/13/2007
1. [FEATURE ENHANCE]
1. [FEATURE ENHANCE]
Enhance the behavior of CI command “ sys atwz <MAC> <COUNTRYCODE>” to
support write homeplug module MAC address and power table automatically. Home Plug
MAC is router’s MAC plus 1, and according to the country code value, corresponding
power table will be uploaded to homePlug module.
MAC is router’s MAC plus 1, and according to the country code value, corresponding
power table will be uploaded to homePlug module.
Modifications in V 3.40(APD.0)C0 | 5/11/2007