ZyXEL p-320w Guía Del Usuario

P-320W User’s Guide

76 

Chapter 4 Wireless LAN

Figure 41   Start OTIST?

2 If an OTIST-enabled wireless client loses its wireless connection for more than ten 

seconds, it will search for an OTIST-enabled AP for up to one minute. (If you manually 
have the wireless client search for an OTIST-enabled AP, there is no timeout; click 
Cancel in the OTIST progress screen to stop the search.)

3 When the wireless client finds an OTIST-enabled AP, you must still click Start in the AP 

OTIST web configurator screen or hold in the Reset button (for one or two seconds) for 
the AP to transfer settings.

4 If you change the SSID or the keys on the AP after using OTIST, you need to run OTIST 

again or enter them manually in the wireless client(s).

5 If you configure OTIST to generate a WPA-PSK key, this key changes each time you run 

OTIST. Therefore, if a new wireless client joins your wireless network, you need to run 
OTIST on the AP and ALL wireless clients again.

The MAC filter screen allows you to configure the Prestige to give exclusive access to up to 
32 devices (Allow) or exclude up to 32 devices from accessing the Prestige (Deny). Every 
Ethernet device has a unique MAC (Media Access Control) address. The MAC address is 
assigned at the factory and consists of six pairs of hexadecimal characters, for example, 00-
A0-C5-00-00-02. You need to know the MAC address of the devices to configure this screen.

To change your Prestige’s MAC filter settings, click the Wireless LAN link under Network 
and then the MAC Filter tab. The screen appears as shown.