ZyXEL g-2000 plusv2 Guía Del Usuario
ZyXEL G-2000 Plus v2 User’s Guide
Chapter 6 Wireless LAN
89
6.7 Configuring WPA(2)-PSK Authentication
In order to configure and enable WPA(2)-PSK authentication, click the WIRELESS link
under ADVANCED to display the Wireless screen. Select WPA-PSK or WPA2-PSK from
the Security list.
under ADVANCED to display the Wireless screen. Select WPA-PSK or WPA2-PSK from
the Security list.
Note: WPA-PSK and WPA2-PSK are two separate choices in this screen. The only
configuration difference between the two is that you can select WPA2-PSK to
be compatible with WPA-PSK. This is highlighted as an extra check box in the
figure below.
be compatible with WPA-PSK. This is highlighted as an extra check box in the
figure below.
Hex
Select this option in order to enter hexadecimal characters as the WEP keys.
The preceding "0x", that identifies a hexadecimal key, is entered automatically.
The preceding "0x", that identifies a hexadecimal key, is entered automatically.
Key 1 to Key 4
The WEP keys are used to encrypt data. Both the ZyXEL device and the wireless
stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal
characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal
characters ("0-9", "A-F").
You must configure all four keys, but only one key can be activated at any one time.
You must configure all four keys, but only one key can be activated at any one time.
The default key is key 1.
Table 26 Wireless: Static WEP Encryption
LABEL
DESCRIPTION