ZyXEL g-2000 plusv2 用户指南

ZyXEL G-2000 Plus v2 User’s Guide

Chapter 6 Wireless LAN

89

In order to configure and enable WPA(2)-PSK authentication, click the WIRELESS link 
under ADVANCED to display the Wireless screen. Select WPA-PSK or WPA2-PSK from 
the Security list.

Note: WPA-PSK and WPA2-PSK are two separate choices in this screen. The only 

configuration difference between the two is that you can select WPA2-PSK to 
be compatible with WPA-PSK. This is highlighted as an extra check box in the 
figure below. 

Hex

Select this option in order to enter hexadecimal characters as the WEP keys. 
The preceding "0x", that identifies a hexadecimal key, is entered automatically.

Key 1 to Key 4

The WEP keys are used to encrypt data. Both the ZyXEL device and the wireless 

stations must use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal 

characters ("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal 

characters ("0-9", "A-F"). 
You must configure all four keys, but only one key can be activated at any one time. 

The default key is key 1.

Table 26   Wireless: Static WEP Encryption