Lorex LW2201 Manual De Usuario

 

14 

The System comes with a camera that has already been paired. The Pairing Function assigns each 
camera to a different channel on the Wireless Receiver (up to 4 Cameras), and is necessary for 
configuring additional cameras. By default, the camera included with the system appears on channels 1 
on the wireless receiver. 
 

Note: It is highly recommended to pair the cameras to the receiver before permanently mounting 
the cameras. 

1.  Connect the power cable from the camera to 

the cable from the Power Adapter; plug the 
Power Adapter into an outlet or surge protector. 

2.  Press the Pair button on the Wireless Receiver 

to select an empty channel. 

3.  Press and hold the Pair button for 5 seconds to 

activate pairing function. The on-screen 
displays informs you that you have 30 seconds 
to press the pair button on the camera (see 
Figure 5.1). 

4.  Press and hold the Yellow Pair button 

extending from the camera. You must press the 
Yellow Pair button from the camera within 30 
seconds of pressing the Pair button on the 
Wireless Receiver. If pairing is successful, live 
video from the camera will immediately appear 
on the monitor. 

 

Auto-Scan automatically switches between channels 1~4. 
Press the Pair button to turn on Auto-Scan 
(CH1~4>Quad,>Auto-Scan). 
 
You can also disable Auto-Scan for individual channels. This 
allows you to customize viewing of the connected cameras. 

To disable Auto-Scan: 

1.  Make sure the Wireless Receiver and cameras are 

fully connected and powered on. 

2.  Press the Pair button to select the channel you wish 

to remove from Auto-Scan. 

3.  Press and hold the VGA/QVGA button until the on-

screen display indicates that Auto-Scan has been 
turned OFF for that specific channel. 

Note: Repeat step 3 to turn Auto-Scan ON. 

Figure 5.0 Pair button on the Wireless 
Receiver 

Figure 5.1 Pair button extending from camera 

Figure 6.0 Auto-Scan turned OFF for 
Channel 1.