Alpine dha-s680 Guía Del Usuario

-EN

Default Settings (SET UP)

NOTE

Press the RTN button to return to the previous screen.

Press and hold the SET button for at least 2
seconds.
The settings are stored and the set up mode is
canceled.

ENT

BAND

RTN

V.OUT

DISP

SET

Changing the down sampling
setting

Some DVDs are recorded using a 24-Bit/96 kHz
linear PCM (LPCM) signal. In order to play these
discs, the signal must be downsampled to 48
kHz/16 bit digital signals before being output
from the optical output.

NOTE

When the settings are changed, the old settings are
overwritten. Make a note of the current settings before
making changes. The settings are not cleared even when
the vehicle’s battery is disconnected.

In the stop mode, press and hold the SET button
for at least 2 seconds.
The setup menu appears.

NOTE

This operation cannot be performed in the PRE-STOP
mode. When the disc is being played, press the ■ button
twice to set the stop mode.

Use the Joystick to select “DOWN SAMPLING”,
then press the ENT button.

OFF

Move the Joystick up and down to choose “ON”
or “OFF” and, then press the ENT button.

The digital signals recorded on the DVD disc with
96 kHz/24bit, 96 kHz/20bit, 96 kHz/16bit, 48 kHz/
24bit, 48 kHz/20bit sampling are converted into
digital signals with 48 kHz/16bits sampling for
output from the optical cable.
Set to ON at time of shipment from factory.

The digital signals recorded on the DVD disc with
96 kHz/24bit, 96 kHz/20bit, 96 kHz/16bit, 48 kHz/
24bit, 48 kHz/20bit sampling are not converted
into digital signals with 48 kHz/16bits sampling.
There is no output from the optical cable.